Athena 1090 EVO, Translation Of Original Instructions, Page: 101 / 182

101
Operating principle:
During travel at a height if an inclination of 0.5° is exceeded, light 1 will start to
flash; if 1° is exceeded, travel will stop.
•
It is necessary to release the joysticks
•
When the joysticks are reactivated, the platform will be levelled again.
The levelling can be performed also by commanding the upward
movement of the work platform.
Warning: If the levelling is performed by means of the joysticks, once the
levelling has been completed, the machine will start to travel
automatically in the selected direction!
When the machine is stopped if the platform is inclined by an angle between
0.5° and 1°, the system will level the platform:
•
By operating the work platform up control
In the case of an exceptional event (ground subsidence, falling from a step,
etc.) and the inclination of the frame is greater than 3°, all movements will be
blocked, both by the main system and by the additional safety system.
•
Light 1 will turn on
•
It is possible to control the "work platform descent" only until the
platform has been completely lowered
If the platform is higher than the transport height and the inclination of the
machine compared to the ground is greater than the value allowed, the travel
and lifting controls will be automatically inhibited
The table below lists the maximum permitted configurations previously
described.