www.atestgaz.pl
8.3
Start-up
The device is ready to operate after the power supply is provided and the co-operating devices are
connected to it.
8.4
Device / system configuration
8.4.1
Relays output configuration
Details of the relays output configuration can be found in Tabels 3, 4 and 5.
8.4.2
Terminators of communication lines
Figure 13: GTW and TETA BUS ports polarization jumpers after removing the cover
GTW and TETA BUS communication ports are equipped with terminators. To configure their work, place
jumpers in the connector. Setting the jumper will activate the port terminator.
8.5
Diagnostics
Information on failures signaled by the device is given in points 5.5.1 and 5.5.2.
8.6
Periodical operations
The device requires periodic testing of the interface – see section 5.3 for details.
8.6.1
Maintenance
Except cleaning the external part of the enclosure, the device does not require any maintenance. The
external part of the enclosure should be cleaned by means of a soft cloth moistened with water and a bit of
a mild detergent.
8.7
Utilization
This symbol on a product or on its packaging indicates that the product
must not be disposed of with other household waste. Instead, it is the
user's responsibility to ensure disposal of waste equipment by handing it
over to a designated collection point for the recycling of waste electrical
and electronic equipment. The proper recycling of your waste equipment
at the time of disposal will help to conserve natural resources and ensure
that it is recycled in a manner that protects human health and the
environment. Information about relevant designated collection points can
be obtained from the Local Authority, waste disposal companies and in the
place of purchase. The equipment can also be returned to the
manufacturer.
s. 29|31
User's Manual: POD-051-ENG R02
GTW port
Terminator
jumper of TETA
BUS port
TETA BUS port
Terminator jumper
of GTW port
