2-21
ASUS ESC8000 G3
2.6
Cable connections
•
The bundled system cables are pre-connected before shipment. You do not need to
disconnect these cables unless you remove the pre-installed components to install
additional devices.
•
Refer to Chapter 4 for detailed information on the connectors.
Pre-connected system cables
1.
20-pin power connector (from the motherboard to the power distribution board) and 4-pin
HDD_PWR1 connector (from the motherboard to the HDD backplane board)
2.
Rear I/O connector (from motherboard to LAN 1 and 2 port on the rear I/O board)
3.
ISATA / ISSATA connectors
4.
USB connector (from motherboard to front I/O board)
5.
DM_LAN connector (from motherboard to rear I/O board)
6.
Auxiliary Panel connector (from motherboard to front I/O board)
7.
Panel connector (from motherboard to front I/O board)
8.
System fan connectors (4-pin CPU_FAN1-4, FRNT_FAN1–8, HDD_FAN1-2 from
motherboard to system fans)
9.
VGA_HDR1 connector (from motherboard to front I/O board)
10. Serial port (COM port)
Summary of Contents for ESC8000 G3
