GETTING ACQUAINTED
4
Tabber Control Panel
1
TRANSPORT POWER SWITCH
–
Turns Tabber transport power ON*.
2
SPEED CONTROL
–
Adjusts Tabber speed.
NOTE: Maximum speed of Tabber is controlled by software.
Tabber Speeds:
Single Tabs: Applies up to 20,000 pieces per hour
Double Tabs: Applies 12,000 pieces per hour
Triple Tabs: Applies 8,000 pieces per hour.
(
Exceeding these speeds causes Tabber to stop
.)
3
LCD DISPLAY
–
Keeps operator informed of Tabber status.
4
KEY PAD
–
Used to set the adjustments and program the Tabber
5
EMERGENCY STOP
–
When Tabber is properly connected to Feeder and/or
other pieces of equipment, pushing this button stops all machines. Turn button
clockwise to release (
reset
) it.
6
SOFT KEYS
–
Used to step through various menu options to program Tabber.
7
STOP KEY
–
Stops Tabber and holds it in a ready state to resume operation.
8
RUN KEY
–
Press to start Tabber when running a job.
9
INFO KEY
–
Press to change display to
Information
mode.
10
SAVE KEY
–
Used to save entries into memory.
11
CLEAR KEY
–
Press to clear any incorrect entry before it is saved in memory.
*Transport power will not activate unless all safety and emergency stop circuits are closed.
