TROUBLESHOOTING
34
CONDITION
SOLUTION
Less of the Tab is on the top of the media than
on the bottom.
Adjust Tab Positioning Knob (
Page 12
)
counterclockwise to place more of the Tab to
the top side of the media.
Tab is not flush with the edge of the media.
Media is not being fed flush with the Fixed
Side Guide. There should be no more than
1/8" to 1/32" space between the media and
the Fixed Side Guide when the media enters
the Tabber.
Check/Adjust Registration Assembly.
When double tabbing one tab is not placed
properly on the edge of the media.
1. Media may not be traveling along the
Fixed Side Guide. Adjust angle of Guide
Rollers by turning knob on Skew Guide.
2. Check pressure between the Head and
the Transport. Too much pressure
causes the media to flex as it is
transported. Too little pressure causes
media to skew as Tab is being applied.
Two or three tabs applied next to each other.
Programming issue. When programming for
multiple tabs
Together
was selected instead
of
Separate
. Or use the
Auto Pos.
feature.
Reprogram the job.
More than three tabs applied on each piece.
1.
Wrong number of tabs selected.
2.
Tab Sensor Adjustment improper.
Check Tab Voltage and Backing
Voltage adjustments. (
Page 24
)
3.
Tabs not threaded correctly (
missing
the Tab Web Sensor
).
