OPERATING THE TABBER
10
3.
Move the Adjustable Side Guide to within 1/32-inch of the media and tighten the
Locking Knob.
4.
Adjust the Rear Media Support Guide so
that the media is approximately 1/2-inch
above the Media Support as shown.
NOTE: This is a starting guideline. Height
of media above Support Guide may vary to
obtain optimum feeding.
5.
Forwarding Rollers on the Feeder are
adjustable for media thickness. This is
particularly helpful when feeding media
over 1/8-inch thick. To adjust the
Forwarding Rollers, loosen the Locking
Knob
[3]
, place a piece of media under
the Forwarding Rollers
[4]
, and then
tighten the Knob.
NOTE: To increase or decrease the
pressure on the Forwarding Rollers,
adjust the lever [5] while tightening the
Locking Knob [3].
Adjusting the Tabber
The Tabber is equipped with two Paper Guides and an adjustable set of Angular Rollers to help
guide the media into position for tabbing. Adjust these Guides as follows:
1.
Place one of the two Media Guides next to the
Fixed Media Guide. Then place the Adjustable
Guide next to it as shown in the photo.
