OPERATING THE TABBER
28
Pressing the
Product-L
soft key from the
“
Select Setup Option
”
screen opens the
“
Enter Product Length and press Save key
”
screen. The following choices are displayed:
Automatic
–
Allows Tabber to automatically
measure and set the piece length. It is highly
recommended that you use
Automatic
to
verify proper media feeding and sensing.
IMPORTANT:
Before pressing the
Automatic
soft key, make sure the Feeder is
turned
OFF
and the Tabber's transport power
switch is turned
ON
BACK
–
Returns to previous screen.
When the
Automatic
soft key is pressed, the
display may prompt you to
“
Increase
Transport Speed
”
or
“
Decrease Transport
Speed
”
. Adjust the transport speed until the
display shows
“
Feed 1 Product now
”
.
When the display reads
“
Feed 1 Product
now
”
, feed one of your mail pieces through
the Tabber.
NOTE:
Feeding more than one mail piece
will cause an incorrect length to be measured
and set.
After the piece has fed through the Tabber, the
Tabber will stop and display the piece length.
Verify the measurement!
It must be accurate (+ or - 0.250").
If the Tabber measures the piece to be
longer
than the actual piece length; then the media may be
slipping or hesitating as it feeds. Check/Adjust the transport system.
If the Tabber measures the piece to be
shorter
than the actual piece length; then the media may
not be feeding straight (
missing the Sensor
), or a hole in the media may be traveling through the
Sensor, or the Sensor may be getting reflection off the mail piece. If using a high gloss media, the
sensor intensity may need to be adjusted lower by a qualified service person.
If the media passes through without the Tabber providing a measurement the Media Sensor may be
dirty. Try cleaning the Sensor as described in this manual. These problems need to be corrected
before the Tabber will function correctly.
