ASTRO astrojet II plus, Installation And Operating Manual

Page: 5 / 62

1
Section 1 –
Introduction
Section 1, Introduction , describes how this manual is arranged. The manual covers
the AstroJet Image Blaster Printer.
Section 2, Getting Acquainted , introduces the AstroJet Image Blaster and describes
the major components, controls, indicators, and important areas with which the user or
operator should be familiar.
Section 3, Installation and Setup , describes how to install the software and get the
AstroJet Image Blaster ready for printing.
Section 4, Operating the AstroJet Image Blaster , describes how to set up the
AstroJet Image Blaster and software to run a job.
Section 5, Operator Maintenance , shows how to replace inkjet cartridges, how to
safely and quickly clear paper jams, and how to care for your AstroJet Image Blaster.
Also, covered in this section are tips and suggestions that will help you increase
efficiency and avoid problems.
Section 6, Trouble Shooting Guide ; gives advice on how to remedy problems that may
occur during use of the AstroJet Image Blaster.
Appendices , is where important but infrequently used information is presented. The
appendices are arranged as follows:
Appendix A, Specifications , lists the more important AstroJet Image Blaster
characteristics, e.g., electrical, physical, etc.
Appendix B, Supplies and Optional Hardware , presents a list of supplies for the
AstroJet Image Blaster and optional equipment which will further enhance its
operation.
Parts Manual , is a break down of the parts in the Image Blaster.