ASTRO astrojet 5000, Service Manual

Page: 9 / 55

SECTION 1
INSTALLATION
3
Connecting the Printer
Plugging in Printer
Make sure Printer’s Main Power Switch is turned OFF.
1. Connect power cord from power pack to connector [4] at rear of Printer.
2. Plug power cord into power pack and then plug other end into a 115-220 Volt AC, 50/60 Hz.
grounded outlet.
CAUTION
USE THE POWER SUPPLY PACKED WITH THE PRINTER.
DO NOT USE AN ADAPTER PLUGS OR EXTENSION CORDS TO
CONNECT THE PRINTER TO THE WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE OUTLETS THAT SHARE THE SAME CIRCUIT WITH LARGE
ELECTRICAL MACHINES OR APPLIANCES.
Connecting to Computer
Printer has both USB [2] and Parallel Port [1]
connections located one above the other. If using the
parallel printer cable from your computer, plug it in and
latch the two locking clips. If using the USB Port
[2] plug
the USB cable into the USB connector.
Main Power Switch [3] should be turned ON after
attaching the power cord to the power receptacle [4] .