ASTRO astrojet 5000, Service Manual

Page: 41 / 55

SECTION 5
DISASSEMBLY
– ASSEMBLY
35
11. Remove torque screw on other end of the
Printhead Carriage Shaft.
NOTE: DO NOT remove Shaft from Print
Engine Assembly. When screw is removed
Support/nut can be removed from Frame.
Set it aside.
12. Remove two screws that attach Print Engine to
Frame on left-hand side and one screw
securing Print Engine to Right-hand Frame.
13. Grasp Print Engine ( as shown ) and lift it
from Frame.
14. Reassemble in reverse order. Make sure that when
installing Print Engine, flat spring for Center Guide Plate
Rod is pointed toward the rear of the Printer.
DO NOT FORGET TO INSTALL THE SPACER
BETWEEN THE LEFT-HAND SIDE FRAME AND
THE PRINTHEAD CARRIAGE SHAFT.