11
3
Reserved
4
Reserved
5
Reserved
6 & 7
Motion pattern selector bits 7 & 6:
00 Reserved
01 Circle
10 Reserved
11 Spiral
This setting can be saved into non-volatile memory by issuing the
[Addr#]SS Z
command
Circles:
Lead-in move assumes start location is center of circle and moves out to X
X +
r
before the circular motion is started.
Spirals:
Spirals start at current location. Presently, no lead-in move is programmed. The spiral
equation is
r = width
/ 2
. . Motion continues to the maximum radius. If mode BIT2
is set, the motion then continues spiraling inward, and continues inward and outward
until halted.
Example:
3MM x=0.02 y=5 z=0.02 f=68
:A
This command sets up the parameters to do a circle pattern for axes on card with
address 3.
3MM x=0.02 y=2 z=0.002 f=196
:A
This command sets up the parameters to do a spiral pattern for axes on card with
address 3.
Summary of Contents for Tiger TG-1000
Page 12: ...11 Change log 53...
