ASI Tiger TG-1000, Instruction Manual

Page: 20 / 79

11
At 32: Z:Piezo v2.4 ADEPT_PIEZO Jun 11 2013:17:05:00
Joystick ready.
System ready.
The card addresses are shown in ASCII code.
At 31
indicates a card with X and Y axes has the address
“1” (ASCII code of 1 is 31).

To save settings in non volatile memory:
1SS Z
(Card-Addressed)

To print its error dump buffer:
1DU Y
(Card-Addressed)

To move X and Y axis:
M X=### Y=###
(Axis-Specific)
Similarly the card with Z axis has address “2” (ASCII code of 2 is 32).

To move Z axis:
M Z=###
(Axis-Specific)

To issue pzinfo command on this card:
2PZINFO
(Card-Addressed)

To put in closed loop external input mode:
2PZ Z=1
(Card-Addressed)

To save settings into non-volatile memory:
2SS Z
(Card-Addressed)

To run short calibration on the piezo:
2PZC
(Card-Addressed)
Table 1 TG-1000 addresses
Addressee Usage Value
TG-1000 Comm Hard coded, re-assignable 0x30 (‘0’)
Stage/ FW/Shutter Unique Address 0x31 to 0x39, then 0x81 to
0xF5
Stage Broadcast Recognized by all stage controllers 0xF6
Filterwheel Broadcast Recognized by all FW controllers 0xF7
Shutter Broadcast Recognized by all shutter controllers 0xF8
LCD Broadcast Recognized by all LCD controllers 0xF9
Broadcast Recognized by all cards 0xFD
Broadcast except
Comm Recognized by all cards except TG-1000
Comm 0xFE