ASG, Division of Jergens, Inc.
15700
S. Waterloo Road | Cleveland, OH 44110-3898 | Phone: (888) 486-6163 | Fax: (216) 481-4519 | Email: [email protected] | Web: www.asg-jergens.com
12
Adjustments and Checks before Use (Continued)
Check and Adjust the Front and Rear Sides of the Rail
Turn OFF the power switch before starting replacement and adjustment.
• If the rail comes into contact with the escape or the clearance between the rail
and escape is too large, loosen the rail screw. Hold the rail groove and adjust the
rail assembly either backward or forward. After making an adjustment, be sure to
tighten the rail screw.
• When the rail comes in contact with the escape, the escape disc doesn’t rotate
properly. When the clearance between the rail and the escape is too large, screws
may fall into the machine.
Check and Adjust the Rear Hopper Cover
Turn OFF the power switch before starting replacement and adjustment.
• Check that the clearance between the rear hopper cover and the rail assembly is
about 0.2 mm.
• If the rail hits against the rear hopper cover, the vibration will lessen and the
screws will be delivered slowly. If the rear hopper cover is too high, the chance of
screws falling between the rail and the scraper increases.
• If adjustment is required, loosen the rear hopper cover screws and make the
appropriate adjustments.
!
!
