Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
Operation and Maintenance
201
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
Procedure:
1.
Change the slot and put the PBX back into operation (similar procedure as de-
scribed in
"Replacing a defective expansion card", page 199
2.
Connect the system terminals to the ports of the new slot.
3.
Re-configure port allocation using the AIMS Configuration Manager.
4.
Insert the card in the new slot in AIMS and remove it from the old slot. The con-
figuration data at the old slot location is now deleted.
6. 3. 3. 2
Special cards
In principle, special cards are changed in the same way as expansion cards. Proceed
as follows:
•
When fitting a special card to a different slot using the AIMS Configuration Man-
ager, remove the card from the old slot location and re-insert it at the new slot
location.
•
Voice Mail cards VM-02 / VM-04:
The configuration and voice data is stored on the Voice Mail card and needs to
be saved separately before the card is changed. For more information see the
System Manual for the Voice Mail System AVS 5150.
•
IP interface cards AIP-6400 and AIP-6500:
The configuration data is stored on a Flash component on the IP interface card
and can be saved in a file. For more information, refer to the System Manual
AIP 6400 and System Manual Ascotel® IntelliGate® Net AIN.
•
Signal processor cards DSP-01 / DSP-02 / DSP-04:
These special cards do not contain any data that has to be saved prior to a card
change.
•
Door intercom interface OI-2DOOR:
This special card does not contain any data that has to be saved prior to a card
change.
6. 3. 4
System cards
System cards are necessary for operating the PBX. There are different memory
cards and the processor card for the 2065 basic system.
