Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
Operation and Maintenance
199
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
the Flash card. This means that configuration data is preserved whenever a defec-
tive terminal card or trunk card has to be replaced by a new one.
6. 3. 3. 1
Installing and removing cards
Replacing a defective expansion card
A card is replaced by the same card type with the same number of ports.
Required tool: Torx screwdriver, size Torx T 10
Procedure:
1.
2.
Remove the PBX cover.
3.
Unscrew the screws on the screening strip and pull out the expansion card com-
plete with screening strip.
4.
Take the expansion card out of the ESD protective sleeve and insert at the slot
for that purpose. Make sure the card is lying in the lower guide slot of the metal
cage and that the ends of the screening strip are flush against the edge of the
metal cage once the card has been inserted.
5.
Screw the screening strip to the metal cage using the 2 screws supplied.
6.
Fit the PBX cover.
7.
Connect the PBX and any ATPS system to the 230 V mains, then connect the UPS
battery where applicable.
Note:
Always fit dummy covers to unused expansion slots to ensure EMC.
See also:
A number of rules have to be observed when fitting the cards (see
"Component mounting rules", page 83
New card with fewer ports
A card is replaced by a similar card with fewer ports.
Procedure:
Change the card and put the PBX into operation again (see
