ASCOM Ascotel AIP 6350, System Manual

Page: 27 / 64

AIP 6350 / Office 35IP
IP Terminal Office 35IP 27
4.6.2 Connecting an IP Terminal Elsewhere
The following describes how to change the point at which an IP terminal is
connected without changing the call number, subscriber name or the terminal
settings. For this the PBX does not have to be taken out of operation:
If the IP addresses of the IP terminal, the default gateway and the AIP card can be
taken over unchanged, proceed as follows:
1. Unplug all the connectors on the IP terminals.
2. Install the IP terminal in accordance with chapter "Installation", page 20,
without adapting the IP addresses.
3. Carry out a connection check.
If the IP addresses must be adapted, proceed as follows:
1. Unplug all the connectors on the IP terminals.
2. Adapt the IP addresses in the AIP configuration with AIMS.
3. Use AIMS to check the settings of the set codec, the allocated bandwidth area
and the allocated static routes.
4. Install the IP terminal in accordance with chapter "Installation", page 20 and
adapt the IP terminal in accordance with chapter "Configuring IP Addresses",
page 22.
5. Carry out a connection check.