ASCOM Ascotel AIP 6350, System Manual

Page: 22 / 64

AIP 6350 / Office 35IP
22 IP Terminal Office 35IP
4.3 Configuration
Equipment and subscriber-specific settings can be made by the user himself via
the terminal or by the system administrator via AIMS. These settings are described
in the Operating Instructions for the Office 35IP.
The IP addresses are entered locally on the terminal by the Installer or System
Administrator.
Note:
The IP addresses are to be entered before the IP terminal is connected to
the network.
The IP addresses remain stored even when the equipment is disconnected.
This means that it is not necessary for the IP terminals to be configured on site;
instead they can be configured prior to the installation.
The menu prompting for entering the IP addresses is only available in English.
4.3.1 Configuring IP Addresses
Proceed as follows to configure the IP addresses:
1. Press the END key until the display reads "Offline Mode".
Note:
Calls cannot be conducted in offline mode.
2. Use the Foxkey to select "Administration".
3. Scroll with the key to the desired IP address (see Tab. 8).
4. Select the desired IP address using the Foxkey.
5. Select "Change", to adapt the IP address:
– Enter all 12 decimal places of the IP address (so for IP address 192.16.3.101
for example, enter the digit sequence "192.016.003.101").
– Use the keys to navigate to the left and right.
6. Confirm the input with "OK".
7. Adapt the other IP addresses in the same way.
8. Press the END key , if you adapted all IP addresses. The display reads
"Restart Office 35IP?"
END
MENU
END