ASCOM Ascotel AIP 6350, System Manual

Page: 15 / 64

AIP 6350 / Office 35IP
Initial Installation 15
3.3.1 Adding AIP Card(s) and IP Terminals
The following describes the procedure for complementing the AIMS master data
with the AIP cards and IP terminals.
1. In offline mode add the required number of AIP cards (card configuration;
CM_1_1_2). Make sure the slot selected in AIMS matches the slot actually
used in the system.
Once you have stored your inputs, AIMS will create 16 virtual user-network
interfaces
1)
with 2 connection possibilities each (MSN 1 and MSN 2) for each
AIP card. As a preconfiguration process AIMS automatically creates subscriber
data including call numbers on all MSN-1 connections.
2. Assign the names and correct call numbers to the subscribers preconfigured
by AIMS (CM_1_1_3_Interface Configuration).
3. Assign the IP addresses to the subscribers in accordance with the layout used
in the planning phase (CM_1_4_5_IP Terminals). Tab. 3 shows the settings
based on the example of the reference model.
4. Enter the IP address and subnet mask of the AIP card (CM_1_4_5_AIP Card).
Tab. 4 shows the settings based on the example of the reference model
Tab. 3: Assignment of user-network interface – IP address based on the example of the refer-
ence model
Tab. 4: IP address and subnet mask of the AIP card based on the example of the reference
model
1)
Only 8 subscribers are preconfigured on the Ascotel IntelliGate 2025. Additional subscribers have to be
created manually on the MSN 2 connection of the user-network interfaces.
IP Terminal User-network interface IP address
511 5.1-1 192.168.104.111
512 5.2-1 192.168.104.112
513 5.3-1 192.168.104.113
521 5.4-1 192.168.111.121
522 5.5-1 192.168.111.122
AIP card 1 IP address Subnet mask
1 192.168.104.101 255.255.255.000