Users can find the DATA interface on the device according to the connector mark described on the rear
panel illustration in section 1.6, and then connect the network cable (CAT5). One end of the network
cable is connected to the encoder’s DATA output connector, and the other end to the TS stream
multiplexer IP input port or other device which can handle IP signal inputs. The encoder’s DATA
connection is illustrated as follows:
Users can find the NMS interface on the device according to the connector mark described on the rear
panel illustration in section 1.6, and then connect the network cable (CAT5). One end of the network
cable is connected to the encoder’s NMS connecter, while the other end should be attached to the
computer or PC. The encoder’s NMS connection is illustrated as follows:
Solutions Provider for FTTx, RFoG and HFC www.ascentcomtec.com
Page 12 of 43
