laserBIRD™ Installation and Operation Guide
10
10
10
10
!
Note:
winBIRD™
is a
Windows® utility
that will allow you
to check out your
setup. It is not
required for normal
operation.
3. Connect the RS232 cable to the laserBIRD and the COM port on the Host PC :
4. Connect the AC Power cord to the laserBIRD power supply and the AC source
(wall outlet)
What you'll notice:
!"
After a short delay (see call-out at left), an audible noise will be heard from
the Scanner. This is the internal mirror shaft, rotating at 3600RPM.
Installing the Utilities
1.
Insert the laserBIRD CD into your PC's CD-ROM drive.
2.
Click on the Install laserBIRD Utility option, and follow the prompts in the Setup Wizard.
3.
Click on the Install winBIRD™ option, and follow the prompts in the Setup Wizard.
Note: A DOS based demo utility, CBIRD.exe, is also available in the \Direct sub-directory of the
CD-ROM.
!
Note:
When
you plug in your
AC Power cord,
there will be a
slight pause, ~3
seconds, while the
system initializes
and the speed of
the rotating shaft is
set. This is normal
operation.
Summary of Contents for laserBIRD
