Asada Beaver 100, Instruction Manual, Page: 22 / 36

5-3
）
Replacing Dies and Die-Head together
〔
Removing and Installing Die-Head from Carriage
〕
(1) Lift the Die-Head halfway.
(2) Position Die-Head on the diagonal and remove.
(3) Only when the Die-Head is adjusted parallel with the flat surface of the Die Head Pin, can it be
removed or installed from the machine.
6) Changing Thread Size
■
For Beaver Die-Head 1/2"-2"AT,21/2"-4"
(1) Make sure that the Die-Head is set on the Carriage and that the Dies corresponds to the thread size.
(2) Set Selector Pin into Selector Block of the required threading size. (fig.25)
(3) Size indicated on each Selector Block.
※
For 1/2"
～
3/4"
，
1"
～
2"
，
1/2"
～
2"
Use silver Selector Pin and block for 1/2" to 1" and black ones for 11/4" to 2"
■
For Beaver Die-Head 1/2"-2"
(1)Ensure that the Die-Head is on the tool carriage and that the Dies correspond to the thread size.
(2)The size is shown on the respective selector block. (fig.26)
21
Removal
Installation
Die Head Pin
Die Head
Replace Die Head
〈
24
〉
Replace Die Head
21
Selector Block(silver)
（
1/2"
～
1"
）
Selector block(black)
（
11/4"
～
2"
）
Selector Pin(silver)
（
1/2"
～
1"
）
Selector Pin(black)
（
11/4"
～
2"
）
〈
25
〉
〈
26
〉
〈
23
〉