5-2) Removing and installing Dies of Die-Head set in Carriage
■
For Beaver Die-Head 1/2"-2"AT,21/2"-4"
[Removal]
(1)
Pull Locking Lever toward A to open Dies.
(2)
Set Selector(silver) Pin into the Dies Selector Block.
(3)
When the Die-Head is lowered, pull out Dies Nos. 1 and 4 from above.
(4)
Lift and remove the Die-Head and pull Dies Nos. 2 and 3 downward.
[Installation]
(1)
Pull Locking Lever toward A to open Dies.
(2)
Set Selector Pin(silver) into the Dies Selector Block.
(3)
Insert the Dies with the same number as that of each Die-Head until click sound is heard.
(4)
Make sure the numbers of Die-Head and Dies show on the same side.
(5) For Dies
2-1/2"
-
4". Position at the first click sound is correct position.
・
Wear gloves to avoid cutting hands by the Dies.
・
Proper threading cannot be achieved unless the number on the Die-Head slot
matches that of the Dies.
〈
16
〉
〈
17
〉
〈
18
〉
18
A
Locking Lever
Selector Pin(silver)
Selector Block
Number shown on
the same side
.
Summary of Contents for Beaver 100
Page 35: ...34 ...