Art's-Way Manufacturing CATTLEMAXX 6105, Operator'S Manual

Page: 17 / 97

INTRODUCTION 15
If supplement is to be added to the ration, a hopper
with a sack cutter is located at the right rear of the
mixing tank. (Figure 6, Detail E (Not Shown)
–
Supplement Auger) The best mixing will result if the
supplement is added before grinding.
The ground feed is mixed continuously until the
tractor PTO is disengaged.
The unloading auger pivots at the rear center of the
mixing tank and can swing 316 degrees on the
grinder mixer in a horizontal arc. (Figure 6, Detail F)
It can also swing in a vertical arc to the limit of the
lift cylinder. The unloading auger tube can be
positioned either to the right or to the left side of the
tank for transport. For procedure instructions, refer
to GRINDER MIXER ADJUSTMENTS - Positioning
The Unloading Auger To The Opposite Side Of The
Machine. Unloading rates up to 30 bushels per
minute can be obtained depending upon position of
the discharge and the type of material processed.
Three viewing windows are located at the front right
corner of the mixing tank to observe the feed level
during grinding and mixing. One viewing window is
located in the back of the tank for added viewing of
feed level. (Figure 6, Detail G.) A ladder is located
at the front left corner of the mixing tank along with
a handle on top of the tank to gain access to the
spring-loaded mixing tank lid.
CAUTION: DO NOT OPEN SPRING-
LOADED MIXING TANK LID WHILE PTO
IS
ENGAGED AND TRACTOR IS
RUNNING.
Many convenient features are standard equipment
on the Art’s Way 6105 grinder mixer including:
105 bu.
– 6105
1. 10.00 x 15 tires.
2. Magnet in the hammermill throat.
3. Hydraulic or mechanical positioning of
discharge auger. This includes a hydraulic
cylinder or mechanical crank for lift and
hydraulic motor or mechanical crank for swing.
4. Positioner to enable the hopper on the auger
feeder to be moved in or out 6 inches to
properly position in front of the augers. (Figure
6, Detail H)
5. Fenders.
6. Screen rack.
7. Tongue jack.
8. Discharge auger hood with spring loaded relief
door.
9. 540 RPM PTO
10. 72 Hammers.
Below is a list of optional attachments available:
1. Auger feeder (hydraulic). (See Figure 7.)
Figure 7 - Model 6105 With Auger Feeder.
2. Electronic scale, with digital readout.
3. Positioning arm for electronic scale box.
4. Horn, light, or horn and light for electronic scale.
5. Unloading auger extensions; 3 ft. or 6 ft. folding
or bolt-ons.
6. Hydraulic roll feed in mill throat hammermills.
7. Highway transport light kit.
8. Electric activated discharge.
9. Hydraulic Discharge (Tractor Operated)
designated with an H behind model number
(i.e. 6105H).