TurboStack Hubs with Management
13
1.
Every TurboStack hub is shipped with a dust cover on the
interrepeater bus port, located on the back of the TurboStack module,
to prevent static discharge and/or damage to the connector pins. Before
the module is installed in a chassis,
the dust cover must be removed,
as
shown in Figure 6.
2.
Remove the rubber feet from the module (see Figure 7).
3.
Be sure to reinstall the screws after removing the rubber feet to
prevent the module casing from expanding and warping (see Figure 8).
Figure 6: Removing
Interrepeater Bus
Dust Cover
Figure 7: Removing Rubber
Feet from Module
Figure 8: Reinstalling Screws
POWER
MASTER
FAUL
T
POWER
MASTER
FAUL
T
IEEE 802.3
/ ETHERNET 1
0 BASE
2
8 PORT HUB
/ REPEA
TER
with Network Management
Dust Cover
Module with dust cover removed
port connector
Interrepeater bus
Module with dust cover installed
Rubber foot
(1 of 4)
Reinstall
screw
(1 of 4)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
