Hardware Installation
16
Note
If you have configured your chassis with both AT-3600 Series modules and
TurboStack modules, you will need to refer to the
AT-3600 Series Hub/
Repeaters and AT-S4 Firmware Module Network Operations Manual.
The
AT-S10 software will not run on a chassis configuration that includes both
AT-3600 and TurboStack modules. See your ATI sales representative for
further details.
Attention
If a fault light illuminates and/or the port activity (link) LEDs on the
Master module illuminate when you first power up a hub, there may be a
problem with the unit. The recommended sequence of corrective steps is as
follows: 1) turn off the power and power up a second time; 2) insert a
firmware cassette in the back-panel port of the unit; 3) initiate a Return
Material Authorization (RMA) to ATI.
For a detailed explanation of ATI’s TurboStack chassis offerings, refer to
the
TurboStack™ Chassis and Backplane Installation Manual,
available
through your local ATI sales representative.
TurboStack Port Configurations
Network Ports
TurboStack hub models feature a variety of port counts and support a
variety of media, including:
❑
Fiber optic (10BASE-FL), using SM, SC or ST connectors
❑
Thinnet (10BASE2), using BNC connectors
❑
UTP/STP (10BASE-T), using Telco RJ21 or RJ45 connectors
❑
Thick Ethernet (10BASE5), using the AUI connector
RS232 Terminal Port
Every TurboStack hub with management capability includes an RS232
Terminal Port on the faceplate. (See Figure 10.)
Figure 10: RS232 Terminal
Port
RS232 port
Appliqué port
(configured as AUI)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
