Arris ICX 7650-48P, Configuration Manual

Page: 71 / 245

the stack formation with the show stack command as shown in the following example. Additional show commands are available
for checking stack status and configuration as described in
Verifying a stack configuration on page 84.
ICX7750-48F Router# show stack
T=10m0.7: alone: standalone, D: dynamic cfg, S: static
ID Type Role Mac Address Pri State Comment
1 S ICX7750-48XGF active cc4e.246d.9e00 128 local Ready
2 D ICX7750-26QXG standby cc4e.2439.3700 0 remote Ready
3 D ICX7750-48XGC member cc4e.2439.1a00 0 remote Ready
active standby
+---+ +---+ +---+
=2/1| 1 |2/4--2/1| 2 |2/4--2/4| 3 |2/1=
| +---+ +---+ +---+ |
| |
|-------------------------------------|
Standby u2 - Learn other units for 7 sec, protocols may not be ready in 63 s.
Role history: N: standalone, A: active, S: standby, M: member
U1: N->A
Current stack management MAC is cc4e.246d.9e00
In the ring stack formed in the example, unit 1 is labeled the active controller, and unit 2 has been assigned the standby
controller role.
Each stack unit produces log entries on stack formation as shown in the following example for unit 2. The log includes
information on synchronization with the stack, reboot, power supply status, and stacking role and configuration. As noted in the
linear stack example, after the unit has joined the stack, its prompt changes (in the following example, to
[MEMBER]
local-2@ICX7750-26Q Router>
) to reflect it is operating as a stack member, not an independent device.
Logs from Master
===============
ICX7750-48F Router# show running-config
Current configuration:
!
ver 08.0.90
!
stack unit 1
module 1 icx7750-48-xgf-port-management-module
module 2 icx7750-qsfp-6port-qsfp-240g-module
module 3 icx7750-6q-6port-qsfp-240g-module
stack-port 1/2/1
stack-port 1/2/4
!
!
!
end
ICX7750-48F Router#
ICX7750-48F Router# stack interactive-setup
You can abort stack interactive-setup at any stage by <ctrl-c>
0: quit
1: change stack unit IDs
2: discover and convert new units (no startup-config flash) to members
3: discover and convert existing/new standalone units to members
2&3 can also find new links and auto-trunk or convert chain(s) to ring.
Please type your selection: 2
Sending probes to ports: u1: 1/2/1 to 1/2/6 1/3/1 to 1/3/6,
Existing stack: ============================================================
+---+
2/1| 1 |2/4
+---+
Horizontal bars link to discovered units. Vertical bars link to stack units.
Building a Stack
Stack construction methods
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01 71