Aritech 2X Series, Installation Manual

Page: 61 / 140

Chapter 3: Configuration and commissioning
2X Series Installation Manual 55
Regional options
Select Regional options to set the regional operating mode. Available options are
shown in the table below.
Table 21: Regional operating modes
Operating mode Region
EN 54-2 (default) European Union
EN 54-2 Evacuation European Union (Spain)
NBN S 21-100 [1] European Union (Belgium)
NEN 2535/2575 [2] European Union (Holland)
VdS 2540 [1] European Union (Germany)
[1] See the corresponding marketplace manuals for additional installation and operation
instructions for these regional operating modes.
[2] Implements NEN 2535 for fire and repeater panels and NEN 2575 for evacuation panels.
To change the control panel operation mode:
1. Select Panel setup from the Main menu.
2. Select Regional options.
3. Select the operating mode.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit)
Remember to apply saved settings from the Main menu.
Firenet configuration
Select the Firenet options to configure the control panel fire network and repeater
settings shown in the table below.
Table 22: Firenet configuration options
Option Description
Firenet map Displays all detected control panels, to add control panels to the
fire network, or to remove control panels from the network. By
default new control panels detected do not communicate with the
network.
Firenet opmode Configures the control panel network operation mode (stand-alone
panel, networked panel, or networked repeater panel).
Repeater map Configures the control panels in the network that the control panel
being configured will repeat.
Global controls Configures global control options for networked control panels and
repeaters.
Event filter Configures the types of events to repeat from other control panels
in the fire network.