EN – 39
Install Flange Bushings
1.
Install flange bushings into pinion gear.
2.
Reinstall pinion gear into chain and align with
differential gear.
3.
Position sleeve bushing between pinion gear and
frame.
4.
Reinstall pinion shaft through frame, sleeve bushing
and pinion gear.
5.
Reinstall one flat steel washer onto pinion shaft.
6.
Insert pinion shaft end into left side of frame.
7.
Position flat steel washer against pinion gear and
reinstall spring clip. See Figure 91.
8.
Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
9.
Reinstall wheel and secure with snap clip.
10. Return unit to operating position.
11. Reconnect spark plug wire and fill fuel tank.
DIFFERENTIAL GEAR REPLACEMENT
Remove Differential Gear
IMPORTANT:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Place unit in service position and remove bottom
cover. See
4.
Remove snap clips from axle ends and remove
wheels.
5.
Remove E-ring from axle end.
6.
Hold differential gear in place and remove long axle
from differential.
Figure 90
Figure 91
WARNING:
AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Make sure unit is secure and will not tip.
Figure 92
