EN – 22
IMPORTANT:
If traction drive clutch cable was removed
from traction clutch lever, reinstall cable to lever. See
Figure 69.
4.
Reinstall traction belt. See
5.
Reinstall auger housing to frame. See
6.
Adjust traction drive clutch. Refer to Operator’s
Manual for adjustment procedure.
7.
Reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
AUGER REPLACEMENT
Remove Auger
IMPORTANT:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Remove auger housing. See
4.
Hold attachment drive pulley in place and remove
hardware securing pulley to impeller shaft.
5.
Remove pulley and spacer from impeller shaft.
6.
Loosen, but DO NOT remove hardware securing
bearing plate to auger housing.
Figure 42
CAUTION:
AVOID INJURY. Attachment drive
pulley edges are sharp. Wear gloves when
handling pulley.
Figure 43
1. Bearing Plate
