EN – 24
12. Remove auger. Use of penetrating oil or heat may be
necessary to remove auger.
NOTICE:
If rust is present on auger shaft, remove with
sand paper and wipe clean with oil.
Install Auger
1.
Install auger onto auger shaft with auger kickers facing
gearcase.
IMPORTANT:
Make sure auger helix direction matches the
original auger orientation.
2.
Apply grease to grease zerk
3.
Align holes in auger with holes in auger shaft and
reinstall shear bolt. Torque bolt to 7.9 – 16.5 N•m
(5.8 – 12.2 lb-ft). If torque wrench is unavailable,
tighten until bolts no longer spin freely. DO NOT
overtighten.
4.
Reinstall flange bushing and support bushing onto
auger shaft end. See Figure 51.
5.
Reinstall auger assembly into housing so impeller
shaft is seated in ball bearing at housing rear. See
Figure 52.
Figure 49
Figure 50
Figure 51
Figure 52
