EN – 40
See Figure 74.
NOTICE:
Sleeve bushing against frame interior will
become free when pinion shaft is moved in next step.
9.
Remove spring clip from left side of pinion shaft and
move pinion shaft left until removed from pinion
sprocket.
10. Remove pinion sprocket from chain.
11. Loosen, but DO NOT remove hardware securing
mount plates to side plates on track carriage. See
Figure 70.
See Figure 75.
12. Remove sleeve bushing seated between bearing
flanges on side plate and frame.
13. Remove hardware securing bearing flange and
remove bearing flange.
NOTICE:
Bearing plate is not a wear item and is not
necessary to replace.
Install Bearing Flange to Right Side of Unit
IMPORTANT:
Bearing plates are ONLY installed with
bearing flanges on frame. Bearing plates are NOT installed
with bearing flanges on side plates.
1.
Install bearing flange and secure with three hex bolts
and three locking nuts. Tighten hardware.
2.
Reinstall sleeve bushings between bearing flanges on
side plate and frame.
3.
Reinstall pinion sprocket into chain.
4.
Position sleeve bushing and pinion sprocket against
frame and move pinion shaft right through pinion
sprocket, sleeve bushing and frame.
5.
Make sure sleeve bushing at left side of pinion shaft is
positioned against frame and reinstall spring clip into
pinion shaft.
6.
Reinstall short axle through side plate and frame.
7.
Reinstall sleeve bushing and flat steel washer onto
short axle.
See Figure 76.
8.
Reinstall differential gear onto short axle and align
with pinion sprocket.
9.
Reinstall long axle into differential gear.
Figure 74
1. Pinion Shaft
2. Pinion Sprocket
3. Sleeve Bushing
4. Chain
2
1
2
4
3
Figure 75
1. Sleeve Bushing
2. Hex Bolt
3. Locking Nut
4. Bearing Flange
5. Bearing Plate
1
2
5
3
4