EN – 9
BOTTOM COVER REMOVAL
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Place unit in service position. See
Service Position
on
page 8.
See Figure 3.
4.
Remove snap clips from axle ends and remove
wheels.
NOTICE:
For track models, it is not necessary to remove
tracks to remove bottom cover.
See Figure 4.
IMPORTANT:
Be aware of key on axle ends. If key is
removed, reinstall before reinstalling wheel.
See Figure 5.
5.
Remove hardware retaining bottom cover to frame
and remove cover.
NOTICE:
For track models, track angle must be in the
“Raised Position” to remove bottom cover. Refer to
Operator’s Manual. See Figure 6.
WARNING:
AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See
Draining Fuel
System
on page 8. Make sure unit is secure and
will not tip.
Figure 3
1. Snap Clip
1
Figure 4
1. Key
2. Keyway
1
2
Figure 5
1. Bottom Cover
2. Hex Bolt
2
1
Figure 6