EN – 16
7.
Reinstall attachment drive belts. See
Install
Attachment Drive Belts
on page 13.
8.
Place unit in service position. See
Service Position
on
page 8.
9.
Remove bottom cover. See
Bottom Cover Removal
on
page 9.
See Figure 23.
10. Check attachment brake:
• Brake must contact attachment belt when
attachment clutch is disengaged.
• Brake must be more than 1.6 mm (1/16”) away from
attachment belt when attachment clutch is engaged.
11. Reinstall bottom cover and secure with six hex bolts.
12. For wheel models, align wheel keyways with axle keys
and reinstall wheels. Secure with snap clips.
13. Return unit to operating position.
14. Adjust attachment clutch / brake. Refer to Operator’s
Manual for adjustment procedure.
15. Reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
Figure 21
Attachment Clutch Disengaged / Brake Engaged
1. Brake Pad
2. Brake Roller
1
2
Figure 22
Attachment Clutch Engaged / Brake Disengaged
1. Brake Pad
2. Brake Roller
1
2
WARNING:
AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See
Draining Fuel
System
on page 8. Make sure unit is secure and
will not tip.
WARNING:
AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
PP
Figure 23