EN – 30
FLANGE BUSHING REPLACEMENT
Remove Flange Bushing
NOTICE:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Place unit in service position. See
Service Position
on
page 8.
4.
Remove bottom cover. See
Bottom Cover Removal
on
page 9.
5.
Remove spring clip from left side of pinion shaft as
shown in Figure 48.
See Figure 53.
NOTICE:
Sleeve bushing between pinion sprocket and
frame will fall when pinion shaft is removed.
6.
Move pinion shaft left until removed from pinion
sprocket.
7.
Remove pinion sprocket from chain.
8.
Remove flange bushings from pinion sprocket.
Install Flange Bushings
1.
Insert flange bushings into pinion sprocket
2.
Reinstall pinion sprocket into chain.
3.
Position sleeve bushing between pinion sprocket and
frame.
4.
Insert pinion shaft through pinion sprocket, sleeve
bushing and frame.
5.
Make sure pinion shaft is centered and spacer
bushing on pinion shaft is against frame.
6.
Reinstall spring clip into left side of pinion shaft.
7.
Reinstall bottom cover and secure with six hex bolts.
8.
For wheel models, align wheel keyways with axle keys
and reinstall wheels. Secure with snap clips.
9.
Return unit to operating position.
10. Reconnect spark plug wire.
WARNING:
AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See
Draining Fuel
System
on page 8. Make sure unit is secure and
will not tip.
Figure 53
1. Pinion Shaft
2. Pinion Sprocket
3. Flange Bushings
1
2
3
3