EN – 36
TRACK REPLACEMENT
Remove Track
NOTICE:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Place unit in service position. See
Service Position
on
page 8.
4.
Remove track drive wheel. See
Remove Track Drive
Wheel
on page 35.
See Figure 65.
5.
Remove track from carriage assembly.
Install Track
See Figure 66.
IMPORTANT:
Tracks are directional and must be installed
with treads in the orientation shown in Figure 66.
1.
Install track onto carriage assembly so bogie wheels
and track runner are seated in track center.
2.
Reinstall track drive wheel. See
Install Track Drive
Wheel
on page 35.
3.
Return unit to operating position.
4.
Adjust track tension. Refer to Operator’s Manual for
adjustment procedure.
5.
Reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
WARNING:
AVOID INJURY. Before placing unit
in service position, close fuel valve and drain fuel
from tank and fuel system. See
Draining Fuel
System
on page 8. Make sure unit is secure and
will not tip.
Figure 65
Figure 66
1. Bogie Wheel
2. Drive Wheel
3. Track Runner
1
3
2