EN – 34
SCRAPER BLADE REPLACEMENT
Remove Scraper Blade
NOTICE:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
See Figure 61.
3.
Remove hardware securing scraper blade ends to
auger housing.
See Figure 62.
4.
Slowly tip unit back so it rests on handlebars.
5.
Remove remaining hardware securing scraper blade
to auger housing and remove scraper blade.
Install Scraper Blade
1.
Position scraper blade inside auger housing and align
with holes in housing.
2.
Insert five flat head square neck bolts through scraper
blade and auger housing from inside housing. Secure
with top locking flange nuts.
3.
Insert two round head square neck bolts through
scraper blade ends, auger housing and skid shoes
from inside housing. Secure with two flat steel
washers and two hex nuts.
4.
Return unit to operating position.
5.
Adjust scraper blade and skid shoes. Refer to
Operator’s Manual for adjustment procedures.
6.
Reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
WARNING:
AVOID INJURY. Before tipping unit
onto handlebars, close fuel valve and drain fuel
from tank and fuel system. See
Draining Fuel
System
on page 8. Make sure unit is secure and
will not fall.
Figure 61
1. Scraper Blade
2. Round Head Square Neck Bolt
3. Flat Steel Washer
4. Hex Nut
1
3
4
2
Figure 62
1. Scraper Blade
2. Flat Head Square Neck Bolt
3. Top Locking Flange Nut
1
2
3