Argox G Series, User Manual

Page: 24 / 75

24
Cutter Mode
Follow the co
mmon procedure of “ Loading Media “ of Standard
Mode from step 1 to 3.
4. Insert the media into the print head module and under the
paper sensor guide. ( Figure 17 )
5. Put back the outside media guide, close the bracket, and
buckle the head latch. ( Figure 18 )
6. Close the top access door and turn on the printer or press the
FEED button if the printer is already on, and then the label will
be fed into the cutter mode automatically. ( Figure 19 )
Note:
The “ FEED “ button will not drive the printer to cut. The
cutting work can be executed only when (1) the software
setting is ready; (2) Bit 3 of DIP switch at rear panel must be
set to the ON position.