Arctic Cat 660 cc, Service Manual, Page: 356 / 396

9-83
9
AG687D
11. Secure the outer idler wheel mounting block with
the cap screw and lock nut. Tighten to 3.2 kg-m
(23 ft-lb).
AG686D
12. Secure the outer idler wheel to the mounting block
with a cap screw, flat washers, idler wheel, axle,
and a lock nut. Tighten to 3.2 kg-m (23 ft-lb).
AG678D
13. Secure the crossbraces with cap screws (coated
with red Loctite #271). Tighten to 1.5 kg-m
(11 ft-lb).
AG511D
„
NOTE: Apply a light coat of grease to the slide
rail surface to aid in installing a new wear strip. If
there are any sharp edges on the lower portion of
the rail, use a file to remove them.
AG534D
14. From the back, start the wear strip onto the rail;
then using a block of wood and a hammer, drive
the wear strip forward into position. Secure with a
machine screw and lock nut. Tighten to 1.1 kg-m
(8 ft-lb).
AG509D
15. Secure the end cap onto the slide rail using a cap
screw, flat washers, and a lock nut. Tighten to
1.1 kg-m (8 ft-lb).