Arctic Cat 660 cc, Service Manual, Page: 129 / 396

4-16
10. Remove the seat assembly.
INSTALLING
0736-891
1. Place the seat assembly into position and connect
the taillight wiring harness.
2. Secure the seat assembly to the tunnel with
washers and cap nuts.
3. Connect the vent hose to the top of the gas tank.
4. Thread the recoil starter rope through the bushing
in the console and the handle; then tie a knot at the
end of the rope and pull the handle up and onto the
knot.
5. Untie the slip-knot at the starter case and allow it
to slowly rewind into the case.
6. Slide the choke cable through the console and
secure with two lock nuts; then using a screw
(coated with blue Loctite #243), secure the choke
knob to the end of the cable.
7. Slide the ignition switch into position on the
console; then secure with the retaining nut.
8. Connect the fuel hose to the carburetor and turn
the gas tank shut-off valve to the OPEN position.
KEY
1. Seat Assy
2. Gas Tank/Seat Base
3. Seat Cover
4. Foam
5. Cap
6. Seal
7. Seat Wire
8. Seat Wire
9. Gas Tank Shut-Off Valve
10. Vent/Fuel Hose
11. Fuel Filter
12. Teflon Tape
13. Taillight Assy
14. Bulb
15. Washer
16. Nut w/Lock Washer
17. Washer
18. Cap Nut
19. Choke Cable
20. Staple
21. Nut
22. Decal
23. Retaining Nut
24. Ignition Switch
25. Ignition Switch Key
26. Lock Nut
27. Cap Screw
28. Decal
29. Push Nut
30. Cable Tie
31. Cable Clip
32. Bushing