Arctic Cat 2018 ZR 200, Service Manual

Page: 56 / 70

55
Steering and Body
Steering Post
REMOVING
1. Remove the handlebar pad.
2. Remove the screw securing the emergency stop
switch to the handlebar; then remove the switch.
ONS-027
3. Remove the clip securing the throttle lever pin in the
throttle control; then remove the pin and lever.
4. Remove the two Torx screws securing the rear throt-
tle control to the front throttle control. Remove the
controls from the handlebar.
ONS-003
5. Disconnect the throttle cable from the lever; then
slide the cable out of the lever.
6. Remove the C-clip securing the throttle cable to the
control; then remove the throttle cable.
7. Remove the screw securing the brake lever assembly
to the handlebar. Remove the assembly.
ONS-024
8. Cut the cable ties securing the cables to the steering
post.
9. Using a sharp knife, cut the grips off the handlebar;
then remove the hand warmers.
10. Using a solvent, clean the old adhesive from the han-
dlebar.
11. Loosen the screw securing the emergency stop
switch to the handlebar; then remove the stop switch.
12. Remove the two cap screws and lock nuts securing
the upper steering post bearings and retainers; then
remove the retainers and bearings.
ONS-025
13. Remove the cap screws, washers, and lock nuts
securing the tie rods to the steering post; then remove
the cap screws and lock nuts securing the steering
post to the chassis. Account for a washer, ground
wire, bearings, and the retainer.
ONS-026