82
MD2426
5. Apply a light coat of grease to spindle shaft; then
install the brake backing plate assembly onto the
shaft.
NOTE: When installing the brake backing plate
assembly, be sure to align the notch in the backing
plate with the tab on the steering knuckle.
MD2381
6. Place the hub assembly onto the spindle; then install
the washer and castle nut. Tighten the castle nut to
50 ft-lb; then install a new cotter pin. Install the
wheel and tighten the lug nuts to 30 ft-lb.
Wheels and Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless tires of
the size and type listed (see General Information - Gen-
eral Specifications). Do not under any circumstances
substitute tires of a different type or size.
TIRE INFLATION PRESSURE
Tire inflation pressure should be as specified in General
Specifications.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
2. Remove the wheels.
NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
CLEANING AND INSPECTING
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING
1. Install each wheel on its hub.
NOTE: Make sure each wheel is installed on its
proper hub as noted in removing (the “rotation
arrow” must indicate forward direction of rotation).
AF612D
2. Tighten to 30 ft-lb.
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air pressure
in each tire. Adjust the air pressure as necessary to
meet the recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.
NOTE: If repair is needed, follow the instructions
found on the tire repair kit or remove the wheel and
have it repaired professionally.
NOTE: Make sure all tires are the specified size and
have identical tread pattern.
! WARNING
Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable ATV operation.
! WARNING
Always use the size and type of tires specified. Always
maintain proper tire inflation pressure.
! WARNING
Do not mix tire tread patterns. Use the same pattern type
on front and rear. Failure to heed warning could cause
poor handling qualities of the ATV and could cause
excessive drive train damage not covered by warranty.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
! WARNING
Do not operate the ATV if tire damage exists.
