45
8. Install the outer starter one-way drive washer with
the word INSIDE directed toward the starter one-
way drive assembly; then coat the crankshaft threads
with red Loctite #271 and secure with the nut (left-
hand thread). Tighten to 68 ft-lb.
TR144
TR191A
9. Install the oil pump baffle and secure with two cap
screws. Tighten to 7 ft-lb.
TR193
10. Install the starter motor (if removed) and tighten the
mounting screws to 7 ft-lb.
11. Install a key in the crankshaft; then install the rotor/
flywheel and flat washer and secure with the rotor/
flywheel nut. Tighten to 40 ft-lb.
TR192
12. Place the two alignment pins and a new gasket onto
the crankcase; then install the magneto cover assem-
bly and secure with the cap screws. Tighten in a
crisscross pattern to 7 ft-lb.
NOTE: Account for the position of the short cap
screw.
TR196A
13. Place the oil through into the end of the crankshaft;
then install the magneto cover and secure with three
cap screws. Tighten to 7 ft-lb.
TR047
