60
TR203A
INSTALLING
1. If removed, connect the vent hose onto the carbure-
tor.
2. If the throttle valve was removed, install the jet nee-
dle (C), needle holder (B), and spring (A) into the
throttle valve (D) making sure the E-clip on the nee-
dle is in the fourth groove (counting from the top);
then connect it to the throttle cable.
TR215A
TR216
TR214
3. Slide the throttle valve into the carburetor making
sure the alignment pin in the carburetor engages in
the throttle valve groove; then secure the assembly
into the carburetor with the cap and tighten securely.
TR202
TR053
4. Connect the gasline hose to the carburetor and secure
with the clamp; then connect the choke cable and
tighten the screw securely.
5. Making sure the O-ring is in position on the carbure-
tor, position the carburetor onto the intake pipe and
secure with two nuts. Tighten securely.
6. Install the air filter and secure the inlet boot to the
carburetor with the clamp; then install two cap
screws to secure the air filter housing to the frame
and tighten securely.
7. Turn the gas tank shut-off valve to the ON position
and check for leaks; then start the engine and adjust
the idle as required (see Engine RPM (Idle) in this
section).
8. Install the left-side heat shield and seat.
