22
MD2452
2. Install the throttle cable into the throttle control
housing; then install the cover and secure with the
screws.
MD2454
KM548A
3. Install the brake cable to the lever assembly.
NOTE: Before installing a handlebar grip, use con-
tact spray or alcohol to clean the inside of the grip
and the handlebar of adhesive residue, oil, or any
other contaminant.
4. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of the grip; then slide the right grip onto
the handlebar. Wipe off any excess adhesive.
5. Tighten the right brake lever assembly screw (from
step 1) securely.
MD2461
Throttle Control
REMOVING
1. Remove the boot from the throttle cable adjuster;
then loosen the jam nut and turn the adjuster com-
pletely in to loosen the cable.
2. Remove the three machine screws securing the cover
to the throttle control; then remove the cover and dis-
engage the throttle cable from the throttle arm.
3. Turn the cable adjuster out of the throttle control
housing; then remove the two machine screws secur-
ing the throttle control to the handlebar and remove
the throttle control.
INSTALLING
1. Making sure the throttle housing upper flat aligns
with the alignment mark on the handlebar, place the
throttle control into position on the handlebar and
secure with the two machine screws; then tighten the
machine screws securely.
KM122B
2. Thread the throttle cable into the throttle housing and
turn the adjuster completely in; then connect the
throttle cable to the throttle arm.
3. Install the throttle housing cover; then adjust the
throttle cable.
