51
TR179A
6. Install the timing chain into the case; then apply
grease to the lips of the crankshaft seal and install the
crankshaft.
TR180
NOTE: To simplify holding the timing chain in posi-
tion on the lower end, pack a small amount of all-pur-
pose grease into the case and “stick” the chain in
place.
7. Install the balancer shaft; then install the right-side
crankcase half with a new gasket.
TR181
8. Lightly tap the case halves together until fully
seated; then secure with nine right-side cap screws
and one left-side cap screw.
TR108A
TR110A
9. Tighten the cap screws (from step 8) in a crisscross
pattern to 7 ft-lb.
10. Install the shift detent ball, spring, and shift detent
bolt. Tighten to 35 ft-lb.
TR109A
11. Install the shift lever aligning the match marks; then
install the cap screw and tighten securely.
CAUTION
Do not draw the case halves together with the crank-
case cap screws. Damage to the case may occur.
