- 44 -
Installation & Maintenance
4.1. Install Hardware
The computer is constructed based on modular design to make it easy for
users to add hardware or to maintain the computer. The following sections will
guide you to the simple hardware installations for the computer.
4.1.1. Open the Computer
For the computer, removing the top and bottom covers is essential to open the
computer and access the inside. Follow through the steps below to remove the
top cover and bottom cover from the computer.
4.1.1.1. Remove Top Cover
All jumpers, MiniCard socket, SDRAM SO-DIMM slots, DIO port and PIO
port (printer port) are built on the top side of the main board. To access these
components, the computer’s top cover has to go. Follow through the steps
below to remove the top cover.
1.
Place the computer on a flat surface. Loosen and remove the 6 screws as
marked in the illustration below.
Summary of Contents for Rigid-772
