23
Press
for two seconds to switch from the 3-display mode to the mode showing the situation of the rows of the connected flowmeters graphically (from 1 to 16).
1
2.30
l/min
43.6 km/h
Pressing
, the central area of the display will show the various speed,
applicationrate and flowrate measurements in extended mode.
The number inside the box on the left and the arrow below the rectangle indicate the
interrogated row.
2
1.20
l/min
43.6 km/h
Press
to move to the next row.
1.55
l/min
43.6 km/h
After selecting the last row, by pressing
the central area shows the detected average
value for all the rows.
The arrow is displayed below every rectangle.
1.55
l/min
43.6 km/h
Press
or two seconds to disable the reading of the data for the row indicated by the
arrow.
An X appears inside the rectangle.
According to the detected values, the rectangles may present in the following modes:
Row is disabled. The quantities measured on this channel
are not used in other counts.
The spray rate of this row corresponds to the required one.
The value is higher than the set limits
The value is lower than the set limits
!
General error on the row. Within the menu, the type of
error can be checked (e.g. temperature, power supply, etc.)
?
The device does not detect the Multiflow corresponding
to this row
Summary of Contents for VISIO MULTIFLOW 4670611
