4
1.
INTRODUCTION
1.1
Product description
VISIO MULTIFLOW is a multifunction display specifically designed to be connected to the ORION MULTIFLOW multi flowmeter.
Up to 4 multi flowmeters, corresponding to 16 channels, can be connected.
2.
INTENDED USE
This device is designed to work on agricultural machinery for spraying and crop spraying applications.
The machine is designed and built in compliance with EN ISO 14982:2009 standard (Electromagnetic compatibility - Forestry and farming
machines) harmonized with 2014/30/UE Directive.
3.
CONTENT OF THE PACKAGE
The table below indicates the components that you will find in the VISIO MULTIFLOW package:
Legend:
1
VISIO MULTIFLOW
2
Fixing kit
4.
PRECAUTIONS
• Do not aim water jets at the equipment.
• Do not use solvents or fuel to clean the case outer surface.
• Do not clean equipment with direct water jets.
• Comply with the specified power voltage (12 Vdc).
• In case of voltaic arc welding, remove connectors from VISIO MULTIFLOW and disconnect the power cables.
• Only use ARAG genuine spare parts and accessories.
5.
INSTALLATION
5.1
Risks and protections before assembly
All installation works must be done with battery disconnected, using suitable tools and any individual protection equipment deemed
necessary.
5.2
Positioning
1) Set mounting rail in cabin and fasten it with the relevant screws (
1
), in a position where VISIO
MULTIFLOW can be easily seen and at hands' reach, but away from any moving organs.
2) Secure VISIO MULTIFLOW to rail and push down until locked in place.
3) Fasten wiring so that it does not interfere with any moving parts.
5.3
Power supply and sensor connection
Sensors and power supply must be installed and connected by qualified personnel.
VISIO MULTIFLOW must be exclusively connected to ARAG equipment.
WHEN ARC WELDING IS REQUIRED, MAKE SURE THAT EQUIPMENT POWER IS SWITCHED OFF; DISCONNECT POWER CABLES IF
NEEDED.
ARAG is not liable for damage to the system, persons, animals or property caused by VISIO MULTIFLOW wrong or unsuitable
assembly. Failure to observe the above instructions automatically voids the warranty.
Wire color
(power cable)
Connection of
red
positive
black
negative
green
counting abort -
ground connection
green
counting abort -
conn12 VDC
Cable kit
for VISIO
MULTIFLOW
to be ordered
separately: COD.
4670611.510
power supply
sensors
Summary of Contents for VISIO MULTIFLOW 4670611
