ARAG VISIO MULTIFLOW 4670611, Installation, Use And Maintenance Manual

Page: 22 / 32

22
10. USE
0.00 l
1
2
0.366
ha
0.482 km
In the 3 areas of the monitor, VISIO MULTIFLOW will display the parameters set in the
Display settings menu.
Press key several times to view a value in extended mode until value is on display
central part.
10.1 PARTIAL TOTALIZER RESET
0.366 ha
1
2
0.482
km
0.00 l
To reset a totalizer you must view it in extended mode.
Press key several times until value to be reset is at the central area of the display.
0.366 ha
1
2
0.000
km
0.00 l
Press key for two seconds.
Totalizer resets.
Setting can or cannot be reset, depending on set value.
Symbol ----- indicates that totalizer exceed maximum value that can be displayed.
Totalizers have a floating point and show a maximum of 4 digits.
Two decimals are shown up to 999.99. One decimal is shown after that and 0 decimals are shown when value reaches 10,000.
...
0.00 l
1
2
ha
18.237 km
99.99
0.00 l
1
2
ha
18.237 km
100.0
1
2
ha
999.9
1
2
ha
1000
0.00 l
18.237 km
0.00 l
18.237 km
The main screen includes the rectangles identifying the single channels.
The ? symbol inside the rectangles indicates that no sensors have been detected so far.
Once the first sensor is connected, the
first 4 rectangles turn off on the screen,
indicating that the detection has been
performed correctly.
When a new flowmeter is connected, the following 4 rectangles will turn off as well.