AQUADUCT CONTROL UNIT
© 2008-2009
Aqua Computer GmbH & Co. KG
- 17 -
Gelliehäuser Str. 1, 37130 Gleichen, Germany
The higher this time, the slower the temperature regulator reacts to
changes in temperature which means that the corresponding fan adjusts
the rpm slowly. For instance when regulating an inert system like the wa-
ter temperature in a cooling system, it would be useful to set this value
to approx. 20 seconds.
This value mainly determines the regulatory behavior at small tempera-
ture differences; at larger temperature differences, the effect from the
regulator factor becomes ostensible.
Default value is 20 seconds for “Water in“ and 3 seconds for all other
sensors.
6.10.
6.10.
6.10.
6.10. Controller factor
Controller factor
Controller factor
Controller factor
This value is only needed if the corresponding fan is in the target-value
mode.
The regulator factor is a multiplier for the temperature difference of the
target-value and causes an immediate adjustment of the rpm of the cor-
responding fan.
The higher this value, the stronger the temperature regulator reacts to
differences in the target value.
Default value is 2.
6.11. Override
6.11. Override
6.11. Override
6.11. Override o
o
o
on/
n/
n/
n/off
off
off
off
Enables/disables the override function for this temperature sensor.
6.12.
6.12.
6.12.
6.12. Back
Back
Back
Back
Leaves the submenu and returns to sensor selection.
7. Men
7. Men
7. Men
7. Menu
u
u
u „„„„Flow
Flow
Flow
Flow sensor“
sensor“
sensor“
sensor“
7.1. Alarm
7.1. Alarm
7.1. Alarm
7.1. Alarm level
level
level
level
If the current flow rate drops below this value, an alarm will be raised.
Additionally, alarm evaluation must be activated for this alarm, for de-
tails see 12.1. Alarm.